This wiki has been archived and made read-only.
For up-to-date information about TkkrLab and it's projects please visit our main website at tkkrlab.nl.

HP450c

From

Jump to: navigation, search

Video How to Load paper

Setup conversion 430 to 450c

In 'EEROM Model ID configuration procedure', pg 4-27 staat hoe je van een 430 omzet naar 450c. Zie ook How to convert a 430 to 450c

Handleiding: HP 430 Service Manual

You will find the following instructions:

  1. Remove the right end cover.
  2. Disconnect the media motor encoder cable from the main PCA (connector ENC X).
  3. Turn the Printer ON while holding the Reprint key down.
  4. Press the Media Source and Media Type keys together to enter the deconfiguration mode. The Fast, Normal and Best LEDs (LEDs ABC) will light up.
  5. Using a suitable tool, short􏰲circuit pins 1 and 2 (the first two pins on the right) of the media motor encoder connector (ENC X). The Cartridges, Data and Media LEDs (LEDs KLM) should light up as you short􏰲circuit the two pins.
  6. Once you have short􏰲circuited the two pins, the Fast, Normal and Best LEDs (LEDs ABC) should light up again.
  7. Press the Cancel and Media Source keys together to exit the deconfiguration mode.
  8. Configure the Printer with the correct model ID as follows:

Only one opportunity is given to perform this procedure and there is no indication that itwassuccessful.

If the Printer is to be configured as a DesignJet 450C (Color) Printer, hold the Media Source key down and press the two Color Configuration (Print Quality + Media Type) keys at the same time.

If the Printer is to be configured as a DesignJet 430 (Monochrome)Printer, hold the Media Source key down and press the two Mono Configuration (Print Quality + Setup) keys at the same time.

If the Printer is to be configured as a DesignJet 455CA (LFP) Printer, hold the Media Source key down and press the two LFP Configuration (Print Quality + Reprint) keys at the same time.

  1. Turn the Printer OFF.
  2. ReconnectthemediamotorencodercabletothemainPCA(connectorENCX).
  3. TurnthePrinterON.Afterinitializing,errorcode􏰳DLM"willappearbecausethe Accuracy Calibration must still be performed.
  4. PresstheCancelkeyandprinttheDemoPlottocheckifthePrinterhasbeencorrectly configured as a DesignJet 430, 450C or 455CA.

If the Printer is still incorrectly configured then Error Code 􏰳EKL" will be displayed on the front panel. Turn the Printer OFF and perform the EEROM Model ID configuration procedure again from step 2.

  1. Performtheaccuracycalibration.


catridges

Te gebruiken cardridges:

  • HP 51640A Zwart [Nummer 40]
  • HP 51644C – cyan [Nummer 44C]
  • HP 51644M – magenta [Nummer 44M]
  • HP 51644Y – yellow [Nummer 44Y]

http://www.khl-inkt.be/inkt/inktpatronen/hp/zoek-op-hp-cartridge-nummer/hp-40/hp-51640a-black-khl-huismerk.html

http://www.khl-inkt.be/inkt/inktpatronen/hp/zoek-op-hp-cartridge-nummer/hp-44.html

Geen originele maar voor 11 euro per stuk inc BTW